MATERIAL SAFETY DATA SHEET

I.   PRODUCT IDENTIFICATION

Manufacturer/Supplier:

ESPI Metals

1050 Benson Way, Ashland, OR 97520

Toll Free (800) 638-2581 * Fax (541) 488-8313

E-Mail: This e-mail address is being protected from spambots. You need JavaScript enabled to view it

Product Name:     DeContam®                                         

CAS Number:       N/A

II.   HAZARDOUS INGREDIENTS

Hazardous Components:   N/A       

Percent (%):                     N/A

OSHA/PEL:                         N/A

ACGIH/TLV:                       N/A

HMIS Ratings:

Health:                               2

Flammability:                    0

Reactivity:                         0

Note:  This product is not hazardous as defined in 29 CFR 1910.1200.

III.   PHYSICAL DATA

Boiling Point:                             >210 ^oF

Specific Gravity:                        1.076                      

Evaporation Rate (BuAc=1):     >1

Vapor Density (Air=1):              >1                           

Solubility in H₂O:                       Complete              

Appearance and Odor:              Clear amber liquid, bland odor.

pH:                                             12.65 – 13.0

IV.   FIRE AND EXPLOSION HAZARDS DATA

Flash Point:  N/A

Autoignition Temperature:  N/A       

Flammable Limits:  Upper:  N/A       Lower:  N/A

Extinguishing Media:  Dry powder, Foam, CO₂, water spray.

Special Fire Fighting Procedures:  Wear goggles and self-contained breathing apparatus.  Use water to keep fire-exposed containers  cool.

Unusual Fire and Explosion Hazards:  N/A

V.   HEALTH HAZARD INFORMATION

Effects of Exposure:

Inhalation:  Mild irritant to the nose, throat and respiratory tract.

Ingestion:  Swallowing a component(s) may cause abdominal discomfort, nausea, vomiting and diarrhea.

Skin:  May cause minor irritation with itching and possible slight local redness.  Prolonged or repeated contact may cause defatting and drying of the skin.

Skin Absorption:  Components are unlikely to be absorbed through skin in harmful concentrations.

Eye Contact:  Mild irritant to eyes.

Systemic and Other Effects:  If a chronic effect has not been mentioned under a route of entry, no chronic effects are known to result from exposure to compounds of this product.

Medical Conditions Generally Aggravated by Exposure:  Skin contact may aggravate an existing dermatitis.

Carcinogenicity:  NTP:  No       IARC:  No        OSHA:  No

EMERGENCY AND FIRST AID PROCEDURES:

INHALATION:  Remove victim to fresh air at once.  Administer artificial respiration if breathing has stopped.  Keep victim warm and at rest.  GET IMMEDIATE MEDICAL ATTENTION.

INGESTION:  If swallowed INDUCE VOMITING.  If victim is conscious, give large amounts of water.  Do not attempt to give fluids to unconscious victim.  GET IMMEDIATE MEDICAL ATTENTION.

SKIN:  Wash skin immediately with lots of soap and water.  If clothes and shoes are contaminated, remove and wash before reuse. Get medical attention if ill effect or irritation develops.

EYE:  Wash eyes immediately with running water for at least 15 minutes.  Use fingers to assure that eyelids are separated and that eye is being washed.  Lift the lower and upper lid occasionally.  GET IMMEDIATE MEDICAL ATTENTION.

VI.   REACTIVITY DATA

Stability:  Stable                                                                                  

Conditions to Avoid:  Stable under normal conditions.

Incompatibility (Materials to Avoid):  None known.                                                                       

Hazardous Decomposition Products:  Carbon monoxide and carbon dioxide on combustion.

Hazardous Polymerization:  Will not occur

VII.   SPILL OR LEAK PROCEDURES

Steps to Be Taken in Case Material is Released or Spilled: Use appropriate protective and safety equipment.

Small Spill:  Sweep spilled material into DOT-approved waste containers for disposal. 

Large Spill:  Shovel spilled material into DOT-approved waste containers for disposal. 

Waste Disposal Information:  Consult appropriate federal, state and local regulatory agencies to ascertain proper disposal procedures.  This product is not a characteristic waste by RCRA definitions.

VIII.   SPECIAL PROTECTION INFORMATION

Respiratory Protection:  None required under usual conditions of use.

Ventilation:  General Exhaust is recommended

Eye Protection:  Contact lenses should not be used.  Contact lenses may increase the severity of the injury.  Suggested protection is safety glasses, but where contact with liquid is likely, chemical goggles or face shields are recommended.

Skin Protection:  Impermeable gloves are recommended.  When prolonged or frequently repeated contact could occur, use protective

clothing.  Selection of specific items such as boots, apron, or full-body suit will depend on operation.  Wash thoroughly after handling chemicals.

IX.   SPECIAL PRECAUTIONS

Precautions to Be Taken in Handling and Storage:  Train all employees on all special handling procedures in this section before they work with this product.  Exercise reasonable care and caution.  Personnel should avoid breathing vapors and/or mists and getting product in the eyes or on the skin.  DO NOT CONSUME food, drink or tobacco in the areas where they may become contaminated with this material.  DO NOT STORE product in direct sunlight, high temperatures or below freezing areas.  Keep product container tightly closed when not in use.  Protect containers from physical damage.

DOT:  Proper Shipping Name:  Non-Regulated

Hazard Class:  Non-Hazardous by 49 CFR 172.101

TSCA:  All components of this product are listed on the US EPA TSCA chemical substance inventory

SARA Title III: No

The above information is believed to be correct, but does not purport to be all inclusive and shall be used only as a guide.  ESPI shall not be held liable for any damage resulting from handling or from contact with the above product.

Issued by:                            S. Dierks

Revised/Verified:                  February 2010